How To Make Decorative Bows With Wired Ribbon. Twist the ribbon one time underneath the bow. You could totally use scraps for this too and could even patchwork some pieces together.
Wired Bow Tutorial Bows diy ribbon, How to make bows from www.pinterest.com
Make a loop to the 5″ mark, turn the ribbon back toward the center, pinching and twisting at the dowels. You could totally use scraps for this too and could even patchwork some pieces together. To decorate a wrapped present, tie ribbon around four sides of the box and tie together in center.
The Reason I Decided To Make My Own Ribbon Was Because I Could Not Find The Right Coordinating Ribbon To Go With My Plaid Decorating Theme.yes, I Am One Of Those People Who Like To Coordinate Everything.
This is a video tutorial on how to make a wired ribbon bow using about 3 yards of wired ribbon, scissors and a twisty tie. Any width will work, but the wider the ribbon you use, the bigger the bow will be. Fold the ribbon over making the loop 1 inch bigger than the loop above it (this makes loop #7) twist the ribbon underneath and hold the twist with your index finger;
(The More Loops You Make The Fuller The Bow Will Be.) Cut The Ribbon Off At A Diagonal And Wave The End Over The Flame.
The width of the ribbon will help determine how large or small your bow is. Come craft along with us as we make this wire bow! You can make a simple bow with any kind of ribbon:
The Bigger The Bow, However, The More Likely It Is To Flop And Not Look As Beautiful As It Should.
You can make a basic bow with any kind of ribbon for example silk, grosgrain, velvet, or even wired. A wide ribbon, a thinner ribbon, and your scissors. That said, you can use unwired ribbon, but the end product will look different.
You Could Totally Use Scraps For This Too And Could Even Patchwork Some Pieces Together.
Place several in a vase for a decorative look or for gift giving, place on a gift wrapped present! Wired ribbon helps keep the shape of the bow, which makes it easier to create. Cut the end of the ribbon in a diagonal cut and wave the end over the lighter to seal it.
Dovetail The Ends By Folding The End Ribbon Together And Cut At The Fold On A 45 Degree Angle Down To The Ribbon Edge.
Make a loop to the 5″ mark, turn the ribbon back toward the center, pinching and twisting at the dowels. Twist the ribbon one time underneath the bow. Cut a length of florist’s wire approximately 12 inches in length and place between the dowels.
